Get webhook notifications whenever Network & Infrastructure creates an incident, updates an incident, resolves an incident or changes a component status.
There's around 3x10G between the vRack 2.0 core and the rbx2-100-n6-vrack following a fault on card 4 of the rbx-g5-a9 router
http://status.ovh.net/?do=details&id=9651 2 links out of 3 stayed down but just on the router side.
Eth1/1 rbx-g5-a9 connected trunk full 10G 10Gbase-LR
Eth1/47 rbx-g5-a9 connected trunk full 10G 10Gbase-LR
Eth1/48 rbx-g5-a9 connected trunk full 10G 10Gbase-LR
Po15 rbx-g5-a9 connected trunk full a-10G --
we switched off the 2 ports then turned them back on
rbx2-100-n6-vrack(config)# inter e1/47
rbx2-100-n6-vrack(config-if)# shutdown
rbx2-100-n6-vrack(config-if)# inter e1/48
rbx2-100-n6-vrack(config-if)# shutdown
rbx2-100-n6-vrack(config-if)# ^C
rbx2-100-n6-vrack(config-if)# no shutdown
rbx2-100-n6-vrack(config-if)# inter e1/47
rbx2-100-n6-vrack(config-if)# no shutdown
it's up
TenGigE0/0/0/5 Full-duplex 10000Mb/s Active
TenGigE0/4/0/0 Full-duplex 10000Mb/s Active
TenGigE0/4/0/2 Full-duplex 10000Mb/s Active
in short, card 4 is la carte 4 is not doing what it should. we will launch the TAC